RF ID card Issuer employes advanced RF transmission cable, featuring high sensitivity, low cost
and good perfomance, suitable with closely issuing card in safety island of parking lot or office.
Remarks:
As protocol and data output of controller are different from different suppliers, the primary
consideration when purchase cotroller is whether issuer protocol is same as controller protocol,
and data format is same or not. If customer need non-standard protocol issuer, protocol instruction
should be provided.
Weigand port
The wiring of issuer is same as reader’s
RS232 port
Include 1 serial port cable, 9-pin serial port female contact and tifurcating cable.9-pin serial port
female contact connect “2-3-5” pin, the other end connect to isuuer’s “GND-2-3” port
Card issuer connects to PP device with RS232 serial port directly, install” serial port test tool” and
read out card numbers, also issue bluetooth card from controller software if RS232 protocol is
matched.
USB port
USB issuer have some data formats: standard hexadecimal, decimal and special data formats
(weigand contoller decimal)
USB issuer connect to computer, create a new “ text file--notepad” and read out card number
directly. The other way is issue card in controller management software if the software support
USB port.
Remarks: when issuing, the issuer just issue one card at one time. Therefore, please manage the
issued cards and estimated cards seperately, otherwise, faults will occur.
Simple troubleshootings
When card issuer power on, the buzzer rings 1 time, the issuer reset already, and enter into normal
working mode. If issuer will not ring or rings all the time after power on, please turn off and
power on again. If the same problems occur again, please check power and confirm whether
strong magnetic interference exist surrounding.
-
Buzzer rings all the time
Cut off power supply and make sure power supply works well, correct polarity; power voltage is
same as issuer’s working voltage
Check surrounding and make sure no strong magnetic interference
If the trouble exist, please remove issuer to other places
Cut off power supply and make sure power supply works well, correct polarity; power voltage is
same as issuer’s working voltage
Powe on, if fail to issue card again, please check whther there are other bluetooth cards, if yes,
please collect the bluetooth cards, as the iusser just issue 1 card at one time.
-
No response after power on ( shortly rings 1 time)
Cut off power supply and make sure power supply works well, correct polarity; power voltage is
same as issuer’s working voltage
No response after power on again, the issuer breakdown